TYPE: SOP
TITLE: Cap SOP

Caps are used to close open areas with flat or rounded coverings.
Meshes are capped by extending the mesh in either the U or V direction,
or adding a face.  Faces are capped by appending a face or hull cap.

Parameters:

U Caps
    Preserve NURB Shape U  - Clamps surface at point of capping.
    First U Cap            - Type of cap to create:
	No end cap	   - The hull is left unmodified at this end.
	End cap faceted	   - A face with unique points is created.
	End cap shared	   - A face with shared points is created.
	End cap rounded	   - The hull is extended with a number
			     of rows whose profiles are circular.
	End cap tangential - The hull is extended with a number 
			     of rows whose profiles are tangential
			     to the original hull.

    Divisions              - Number of cross-sections in the cap.   /firstcapu
    Scale                  - Height of the rounded cap.             /firstscaleu
    Last U Cap             - Type of cap on the other end.
    Divisions              - Number of cross-sections in the cap.   /lastcapu
    Scale                  - Height of the rounded cap.             /lastscaleu

V Caps
    Overview - Similar to U Caps tab, but builds caps   /firstcapv  /firstscalev
               in the other direction.                   /lastcapv   /lastscalev

See Also: PolyCap
